Also, the serial port shows up correctly as the dev/ttyUSB assigned to the Plug & Play. The baud rate for the 756PROII is set at 9600 baud, so I know that part of the set up is correct. The WSJT-X software is able to receive and decode FT-8 with no problems, but I am unable to get the PTT settings to work. I am using an older HP desktop converted to Linux (running Ubuntu Mate distribution), with a West Mountain Radio Rig Blaster Plug & Play as an interface between the computer and radio. I am trying to finalize the setup of IC-756PROII to work with WSJT-X. Any suggestions on the correct settings to get this to work would be greatly appreciated. I was able to get another digital mode program, FLDIGI, to work using their FLrig software, using the listed settings and RTS, but as indicated this does not work with WSJT-X. I have tried with the PTT settings on CAT and RTS, both result in the radio immediately going into transmit mode. I believe the correct settings for the 756PROII to be 9600 baud, 8, N, 1. However, as soon as I activate the PTT settings, the transceiver immediately goes to transmit mode, and the Transmit button ion the radio has no effect in turning it back to receive, and I then get a rig control error message.
0 kommentar(er)
